Hole trough hole? Advice pls

General Discussion
1

Hi,

I’m making a very simple replacement part, a locking knob to large format camera. This has a axel of 5mm, and are held innplace with a 2,5mm locking pin.
My challenge starts when I’m trying to make the hole for the pin, where it becomes a solid in the axel hole. Tried to delete the exposed part in the axel hole, however does not give the desired effect at all…

Any advice on how to achieve the objective?

1 Like
2

Hi @Morten,

We’re aware of this issue. In this case there’s a need in “Subtract” surfaces, which we’re working on to bring into uMake soon.

Sorry for the temporarily inconvenience.

Thanks,
Evi

1 Like
3

Thanks! Look forward to that!

1 Like